Why Shortwave IR is the Secret to Better Glass Annealing If you’re running a glass production line, you know the pain of the “lag.”...

Stop Wasting Heat on Your Glass Additives Most infrared lamps just blast a broad wave of energy. For basic drying, that’s fine. But when...

Stop Wasting Power on Your Glass Annealing Lines Let’s be honest: annealing lines are absolute energy hogs. Most shops I talk to are just accepting...

Stop the Shatter: Getting Glass Annealing Right If you’ve ever spent hours fabricating lab-grade glass only to have it spontaneously shatter,...

Stop Worrying About Voltage When You’re Setting Up IR Heating If you’ve ever tried to roll out an infrared heating line across different...

How to Stop Your Glass from Cracking During Tempering Working with glass is always a bit of a tightrope walk. You need to get it hot fast to keep the...

Stop Letting Backordered Parts Kill Your Production There is nothing worse than watching a production line go dead because some OEM spare part is on...

Stopping Glass from Cracking During Tempering Ever had a piece of glassware just… snap? It’s frustrating. Usually, it happens because the...

If you’ve ever tried to cut through ultra-thick Glass, you know the struggle. A sharp tungsten carbide wheel is a start, but it’s usually...

Getting Your 3-Meter+ IR Heaters Right for Low-E Glass If you’re preheating wide-format Low-E glass, you know the struggle. You need the heat...

Getting the Heat Right: A Look at SK15 Ceramic Lamp Holders If you’re working on new glass materials, you already know that off-the-shelf...

Stop Wrestling With Single Tubes: A Better Way to Handle IR Heating Most glass sealing jobs start simple—just a standard straight lamp and...

Introduction Ever watch a piece of glass crack in the kiln and just sigh? It’s usually because of those stubborn “cold spots”—areas the...

Introduction We built this infrared drying lamp for one reason: to dry high-performance Low-E glass coatings without scorching the film. Speed is...

On the line, glass doesn’t wait. A feeder heating lamp that drifts off-target or lags while chasing temperature will eat minutes, scrap, and margin....

On the glass line, heat isn’t just a number on a chart—it’s control. When the oven misses, you feel it immediately: optical distortion...

On the glass line, heat control isn’t a perk—it’s the line between making parts and making scrap. Whether you’re tempering, bending, or drying...